Snap kit designed for the Catalyst Machineworks Merica 5 Inch Hybrid frame, fitting all Merica variants with at least five inch prop clearance, and sporting a sixty-five degree fixed camera angle.  Quarter mile weapon.  Accomodation for the intercontinental ballistic sprint, by Snap Aerial Silhouettes.

 
 
                                            Features
Super-resolution, semi-flex TPU canopy construction, advanced material boasts a 580% elongation coefficient, 95A shore hardness rating, and peerless, opaquely reflective finish; less jello than nylon, and no cracking in cold weather.
 
Proven Bleeding Shell passively retractable camera mount, which lets the camera slide back into the protected area of the canopy during direct hits and hard crashes, tested for absolutely no unintended camera slippage.
 
Turtle mode without fin or stick, due to higher ground contact made possible by proprietary hull geometry.
 
Stainless steel internal threads for far greater aerodynamic efficacy than traditional exposed-hardware designs, while still mounting using the frame's stock hardware.
 
Onboard, internally wired SUNON MagLev server fan with high speed Vapo-Bearing and accompanying Tiny's Pico Rainbow RGB LEDs (digitally addressable as a three node string).

 
 
                                               Notice
THIS KIT ASSUMES THE USE OF ZIPTIE/ARM MOUNTED RADIO SIGNAL RECEIVER ANTENNAE, AND LIGHTWEIGHT CIRCULAR POLARIZED OR LINEAR VIDEO TRANSMISSION ANTENNAE.
 
THIS KIT DOES NOT ACCOMODATE FLIGHT CONTROLLER MOUNTING IN THE CANOPY ITSELF; 20X20 STACK (TO FIT INSIDE TOP PLATE VIDEO TRANSMITTER CUTOUT) OR INDIVIDUAL ARM MOUNTED ELECTRONIC SPEED CONTROLLERS (WITH FLIGHT CONTROLLER MOUNTED TO BOTTOM PLATE) MUST BE USED.
 

 
                                           Interfacing
The red wire from the canopy goes to 5V on the flight controller, the black wire from the canopy goes to ground on the flight controller, and the yellow wire from the canopy goes to the LED signal output on the flight controller; the included RunCam Racer Nano should be wired according to its digital manual, using the provided JST pigtail.
 
Canopy mounts using the frame's stock hardware.  Apply medium strength threadlocker to camera screws, but DO NOT apply any threadlocker to canopy mounting screws.
 
 
 
                                             Fitment
Only guaranteed to fit the included RunCam Racer Nano camera, which features an extremely low profile and mass, state of the art gesture control, and optical performance equal to that of the RunCam Racer 2.
 
Camera saving feature setup video: https://www.instagram.com/tv/CAeRJ9_gtAe/?igshid=13aaiv2k98i2y
 

 
                                           Contents
One Snap canopy, one RunCam Racer Nano camera in its original packaging, four black contractor quality Cambridge zipties for radio signal receiver/video transmission antennae mounting, five stainless steel BelMetric nyloc aero-propnuts, five black Pyro Drone Hyperlite machined aluminum propeller shaft spacers, one JST pigtail for the canopy, and one JST pigtail for the camera.
 
 
 
                                             Weight
Canopy-with internal components, adhesives, and inserts-weighs approximately 41.9 grams, and the RunCam Racer Nano weighs 3.5 grams.